HP Xw4550 - Workstation - 2 GB RAM Technical Reference Manual page 37

Table 3-1 Computer Setup (F10) Utility menu descriptions (continued)
Heading
Security
ENWW
Option
Boot Order Enables you to configure the boot, diskette drive, and hard drive orders by physically reordering
the menu entries. The default boot order presents these selections:
● ATAPI – CD-ROM Drive
●
Diskette Drive
● USB Device
● Hard Drive
●
Broadcom Ethernet controller
Press Enter to drag a device to a preferred place. Press
as a bootable device.
NOTE: MS-DOS drive lettering assignments might not apply after a non-MS-DOS operating
system has started.
Boot devices can be disabled from participating in the boot order process. These order changes
are reconciled with the IPL/BCV historical information and stored in the physical ROM part when
the F10 Setup changes are confirmed with File/Save Changes and Exit.
You can temporarily override the boot order. To boot one time from a device other than the default
device specified in Boot Order, restart the workstation and press
message appears on the screen. After POST completes, a list of bootable devices is displayed.
Use the arrow keys to select the preferred bootable device and press
boots from the selected non-default device for this one time.
Setup Password Enables you to set and enable setup (administrator) password.
NOTE: If the setup password is set, it is required to change computer setup options, flash the
ROM, and make changes to certain PNP settings under Windows.
Power-On Enables you to set and enable the power-on password.
Password
Password Lock Legacy Resources–Prevents the operating system from changing resources to serial and
Options diskette controller.
Setup Browse Mode–If a setup password is created, this mode enables read-only access to the
F10 Setup menu for users without a password.
Smart Cover Allows you to disable cover removal sensor or to notify user if sensor has been activated.
Device Security Makes the following devices available or unavailable to the system:
● Serial port
●
All USB ports
●
System audio
● Network controller
● Embedded Security Device
For each device, Device Available is the default setting and allows the operating system access
to the device. Device Hidden makes the device unavailable; it is disabled by the BIOS and cannot
Description
F5 to remove the device from consideration
F9 when the F9=Boot Menu
Enter.
Computer Setup (F10) Utility
The workstation then
29