Volvo 240 Owner's Manual page 117

Volvo 1990 240 Model
Polishing (waxing)
Normally, polishing is not required during the first year after delivery. Waxing may be beneficial.
Before applying polish or wax the car must be washed and dried. Tar spots can be removed with
kerosene or tar remover. Difficult spots may require a fine rubbing compound.
After polishing use liquid or paste wax.
Several commercially available products contain both polish and wax. Waxing alone does not substitute
for polishing of a dull surface.
A wide range of polymer based car waxes can be purchased today. The waxes are easy to use and
produce a long lasting high gloss finish which protects the bodywork against oxidation, road dirt and
fading.
Cleaning the upholstery
Generally the fabric can be cleaned with soapy water or a detergent. For more difficult spots caused by
oil, ice cream, shoe polish, grease, etc., use a stain remover.
The plastic in the upholstery can be washed.
To clean leather upholstery , use soft cloth and mild soap solution, for instance common bath soap.
For more difficult spots, consult an expert for the choice of cleaning agent.
On no account must gasoline, naphtha or similar cleaning agents be used on the plastic or the leather
since these can cause damage.
When aging, leather changes appearance, but the typical texture remains. To preserve smoothness and
appearance, it is recommended to treat the leather with a special leather preservative after one or two
years of use.
Cleaning the seat belts
Clean only with luke warm water and mild soap solution.
WARNING! Do not use cleaning solvents to clean the seat
belts.
Cleaning floor mats
file:///K|/ownersdocs/1990/1990_240/90240_18.htm (3 of 8)12/30/2006 8:25:11 AM