Trip Computer Display In Odometer Display - Vauxhall Corsa Owner's Manual

94 Instruments, controls
Speed warning
With "Personalised key" function P6
(see pages 40, 42), a certain maximum
speed can be assigned to each vehicle key.
If this speed is exceeded, a warning buzzer
will be heard.
This function is programmed in the
odometer display:
z turn ignition off and leave key in starter
switch,
z pull turn signal stalk and wiper stalk
simultaneously to the steering wheel
until you hear a confirmation signal
(approx. 3 seconds),
z the odometer display shows P1,
z push down the turn signal stalk (left) until
P6 appears,
z push the wiper stalk (right) up until the
desired speed appears in increments
of 10,
z to reduce the speed or switch off (OFF),
push the wiper stalk down,
z pull turn signal stalk and wiper stalk
simultaneously to the steering wheel
until you hear a confirmation signal
(approx. 3 seconds).
This function can be programmed
differently for each vehicle key.
Personalised key – see page 40,
Cruise control 3 – see page 168.
Trip computer display in
odometer display
3
The trip computer provides information on
driving data, which is continually recorded
and evaluated electronically.
After switching on the ignition, the last
function displayed appears. To select a
different function, rotate the rotary switch
i
on the wiper stalk briefly up
and then let go. The functions will be called
one after the other.
To reset a value or confirm a warning
message, press button 0 on the wiper stalk.
h
or down