Sunbeam EM6910 Cafe Series Instruction Booklet page 38

Advanced programming options continued
Steam Wetness or Steam Pump Rate
The steam pump rate of this espresso
machine has been set at 0.3 seconds on and
0.5 seconds off. Modifying the steam pump
rate enables you to make the steam wetter or
dryer and aids in the delivery of a powerful,
dry steam - ideal for texturing milk. The
steam pump rate (off time) can be modified
in increments of plus or minus 0.1 seconds
should it be desired.
To do this you need to follow the instructions
below:
1. I nsert the power cord into a 230-240V AC
power outlet and switch the power 'ON'.
Note: Although the espresso machine is ON
at the power outlet ensure that the actual
espresso machine power is 'OFF'. Therefore
no lights will be illuminated on the espresso
machine control panel.
2. P ress and hold down the 'PROGRAM'
button.
3. W hile still holding down the 'PROGRAM'
button briefly press the 'POWER' button
and release.
4. R elease the 'PROGRAM' button.
+0.2 sec +0.1 sec
off off
Note: This activates the programmability of
the Steam Pump Rate and to signal this, the
light above the ' single espresso' button
will illuminate, which is the factory setting.
36
Factory -0.1 sec -0.2 sec
off off
Setting
Note: The light above the ' single espresso'
button will remain on and then if you have
already re-programmed the Steam Pump Rate
the position of the light will move to one of
the other 4 settings indicating the current
setting.
Note: This light will remain on for up to 5
seconds before automatically returning to
the Factory Setting if no action is taken. The
espresso machine will then power on and
begin heating up.
5. W ithin 5 seconds press and release one
of the buttons below depending on the
required adjustment;
-0.1 sec = Press the '
-0.2 sec = Press the 'PROGRAM' button (wetter)
+0.1sec = Press the 'MANUAL' button (dry)
+0.2 sec = Press the 'POWER' button (dryer)
Note: When you have selected a new pump
rate setting the light above the button
pressed will illuminate and to indicate that
the setting has been changed correctly the
light will flash and 2 beeps will sound.
Note: The espresso machine will then
automatically power on and begin heating up.
Remember: If you do not select a new pump
rate setting within 5 seconds the program
will return to the Factory Setting and the
espresso machine will then power on and
begin heating up.
double cup' button (wet)