Sunbeam EM6910 Cafe Series Instruction Booklet page 37

Advanced programming options continued
Steam Thermoblock Temperature
The steam temperature of this espresso
machine has been calibrated to deliver a
powerful and dry steam for texturing milk.
The temperature of the steam can be
modified in increments of 5°C up and down
should it be desired.
To do this you need to follow the instructions
below:
1. I nsert the power cord into a 230-240V AC
power outlet and switch the power 'ON'.
Note: Although the espresso machine is ON
at the power outlet ensure that the actual
espresso machine power is 'OFF'. Therefore
no lights will be illuminated on the espresso
machine control panel.
2.Press and hold down the '
espresso' button.
3. W hile still holding down the '
espresso' button briefly press the 'POWER'
button and release.
4.Release the ' double espresso' button.
Note: This activates the programmability of
the Steam Thermoblock Temperature and
to signal this, the light above the ' single
espresso' button will illuminate, which is the
factory setting.
-10°C -5°C
double
double
Factory
+5°C +10°C
Setting
Note: The light above the ' single espresso'
button will remain on and then if you have
already re-programmed the temperature of
the steam thermoblock the position of the
light will move to one of the other 4 settings
indicating the current temperature setting.
Note: This light will remain on for up to 5
seconds before automatically returning to
the Factory Setting if no action is taken. The
espresso machine will then power on and
begin heating up.
5. W ithin 5 seconds press and release one
of the buttons below depending on the
required temperature adjustment;
+5°C = Press the '
+10°C = Press the 'PROGRAM' button
-5°C = Press the 'MANUAL' button
-10°C = Press the 'POWER' button
Note: When you have selected a new
temperature setting the light above the
button pressed will illuminate and to indicate
that the setting has been changed correctly
the light will flash and 2 beeps will sound.
Note: The espresso machine will then
automatically power on and begin heating up.
Remember: If you do not select a new
temperature setting within 5 seconds the
program will return to the Factory Setting and
the espresso machine will then power on and
begin heating up.
double cup' button
35