6.2 Bobbin case support
2
24
3
Caution: Risk of injury!
Turn off the main switch!
Check and set the bobbin case support only with the sewing machine
switched off.
Standard checking
The bobbin case support is factory set.
After a replacement of the support, the new support may eventually
need to be adjusted.
ATTENTION RISK OF BREAKAGE!
The adjustment can only be carried out within the hatched area 4.
(see sketch)
Due to the extreme hardness within the area of the retaining tab 1, a
risk of breakage is there.
Correction
–
Remove the bobbin case support 1.
–
Align the bobbin case support 1.
The distance between the retaining tab 2 of the bobbin case
support and the lower part of the bobbin case 3 should be 0.6 mm.
–
Mount the bobbin case support 1.
1
2
4
3