Table of Contents
Advertisement
Receiving and Ending Phone Calls
Receiving a Phone Call
Ending a Phone Call
Volume
Microphone Mute
Audio Transfer
Call Waiting
Call Hold
XDMA7600
Bluetooth
Incoming phone calls will automatically appear on the display
and a ring tone will be heard.
Note: The volume of the ring tone depends on the volume
level of the XDMA7600. The incoming ring tone may not be
heard if the volume is set to a low level or mute is activated.
• Press
to receive the incoming phone call.
• Press
to refuse the incoming phone call.
Note: If Auto Answer is set to ON in the setup menu, all
phone calls will be received automatically.
During an active phone call, press
If the phone call was received when listening to music in
another mode, the XDMA7600 will resume the previous
mode.
During a Phone Call
Turn the volume knob to adjust the volume level during a
phone call. Bluetooth mode has a separate volume level
from the main volume of other modes. The XDMA7600 will
remember the volume level in Bluetooth mode and always
return to the last volume level for each phone call.
Press MUTE during a phone call to turn the XDMA7600's
external microphone off. Press MUTE again to resume
microphone operation.
Press DISPLAY during a phone call to transfer the call from
the XDMA7600 to the cell phone. Press DISPLAY again to
toggle the audio back to the XDMA7600.
During a phone call, if there is a second incoming call, press
to place the first call on hold and switch to the second
phone call. Press
During a phone call, when there are no additional incoming
calls, press
to place the call on hold. Press
resume the phone call.
Note: Audio transfer, call waiting and call hold must be
supported by the mobile phone and service provider to
function properly.
23
®
to end a phone call.
again to switch back to the first call.
Operation
again to
Advertisement
Table of Contents
