Lenovo ThinkCentre M71e Hardware Maintenance Manual page 62
Machine types: 3129, 3132, 3133, 3134, 3136, 3140, 3141, 3143, 3146, 3147, 3150, 3154, 3156, 3157, 3166, 3167, 3169, 3171, 3175, 3176, 3177, 5033, 5036, 5039, 7338, and 7339
Hide thumbs
Also See for ThinkCentre M71e:
- (142 pages) ,
- User manual (140 pages) ,
- Benutzerhandbuch (138 pages)
Table of Contents
Advertisement
Diagnostic Error Code
011-196-XXX Serial port test halt, error threshold
exceeded
011-197-XXX Serial port test warning
011-198-XXX Serial port test aborted
011-199-XXX Serial port test failed, cause unknown
011-2XX-XXX Serial port signal failure
014-000-XXX Parallel port Interface Test Passed
014-001-XXX Parallel port Presence
014-002-XXX 014-003-XXX Parallel port Timeout/Parity
error
014-013-XXX 014-014-XXX Parallel port Control
Signal/Loopback test failure
014-015-XXX Parallel port External Loopback failure
014-027-XXX Parallel port Configuration/Setup error
014-03X-XXX 014-04X-XXX Parallel port failure
014-195-XXX Parallel port Test aborted by user
014-196-XXX Parallel port test halt, error threshold
exceeded
56
ThinkCentre Hardware Maintenance Manual
FRU/Action
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility program" on page 43
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility program" on page 43
2. Flash the system and re-test. See "Updating
(flashing) the BIOS from a disc" on page 391
3. Go to "Undetermined problems" on page 71
1. Go to "Undetermined problems" on page 71
2. Flash the system and re-test. See "Updating
(flashing) the BIOS from a disc" on page 391
3. Replace component under function test
1. External serial device
2. System board
No action
1. Remove external parallel device, if present
2. Run setup, enable port
3. System board
System board
System board
1. Wrap plug
2. System board
1. Run Setup, enable port
2. Flash the system. See "Updating (flashing) the BIOS
from a disc" on page 391
3. System board
System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
Hide quick links:
Advertisement
Table of Contents
