Hard Disk; Removing The Disk Retaining Bracket - HP Model 712/100 - Workstation Handbook

Hard Disk

Before removing the hard disk, perform the following procedures:
Remove the stand.
Open the system unit.
Perform the following steps to remove the disk drive:
1. Disconnect the SCSI and power cables from the hard disk.
2. Remove the disk retaining bracket by lifting the end closest to the rear of the sys-
tem unit and rotating it toward the front of the system unit, as shown in
Figure 5–16.
Figure 6–16. Removing the Disk Retaining Bracket
5–26 Field Replaceable Units