Citizen CBM1000II Command Reference Manual page 72

GS V m ......... (1)
GS V m n ..... (2)
[Function]
[Code]
[Range]
[Outline]
[Caution]
CAUTION:
When using label sheet:
• Be sure to cut the base sheet at every label gap. Otherwise, the cutter performance
will be immensely degraded.
• Never open the printer cover while printing as proper print operation may not be
guaranteed. Opening the printer cover may alter label length setting or other
parameters.
• Never use label rolls with different label sizes or label gaps as proper print
operation will not be guaranteed.
Cutting the paper
(1) <1D>H<56>H<m>
(2) <1D>H<56>H<m><n>
(1) m = 1, m = 49
(2) m = 66
0 n 255
Performs the specified paper cutting.
m
1,49 Partial cut (Leaving a bridge area uncut)
Paper feed by "cut position + {n
66
pitch}"and partial cut (Leaving a bridge area uncut)
• Fully cut for the label sheet specs.
• In STANDARD MODE, this command only works when it is
entered at the beginning of a line.
For (1):
• A partial cut (Leaving a bridge area uncut) is executed.
For (2):
• If n = 0, the paper is fed to the cut position, and then cut. If n
0, the paper is fed by "n
past the cut position, and then cut.
• The basic calculation pitch is set by GS P.
The paper feed amount is calculated with the vertical basic
calculation pitch (y).
A fraction resulting from the calculation is corrected with the
minimum pitch of the mechanism, and the remainder is
omitted.
— 70 —
Function
basic calculation
basic calculation pitch" inches