Citizen CBM1000II Command Reference Manual page 112

GS c
[Function]
[Code]
[Outline]
[Caution]
[See Also]
[Print Result]
GS I n1L n1H n2L n2H
[Function]
[Code]
[Range]
[Outline]
[Caution]
[Default]
Print the counter
<1D>H<63>H
This command prints the serial number counter data. After setting the
current counter value in the print buffer as the print data (Character
string), it increments or decrements the counter according to the set
count mode.
• When setting the value in the print buffer, its format depends on the
GS c command, the counter will be initialized to the set default.
GS C0 , GS C1 , GS C2 , GS C ;
See the sample programs and print results for the GS C1 command.
Setting the label length
<1D>H<6C>H<n1L><n1H><n2L><n2H>
0 n1L 255 (24
0 n1H 1
8 n2L 30 (Label paper)
4 n2L 8 (Black mark paper)
n2H = 0
Define the specifications (length) of the label used.
n1: Sets the label length (Gap between black mark paper)
n2: Sets the label gap length (black mark paper length)
nl and n2 are specified units of millimeters.
Divide the maximum label length by 256 and make the quotient n1L
and the remainder n2H.
• If the specified length is outside of label specifications, the default
length is set.
• 360 mm is the maximum label length allowed to define and 24 mm is
the minimum.
• 30 mm is the maximum allowable label gap length to define and 8
mm (4 mm black mark paper length) is the minimum.
• The following default values are set when DS2-9 is set to ON.
Label paper:
Label length = 25 mm (n1L=25 n1H=0): Label gap length = 8 mm (n2L=8
n2H=0)
Black mark paper:
Black mark paper gap = 25 mm
(n1L=25 n1H=0)
Black mark paper length = 4 mm
(n2L=4 n2H=0)
(Only for Label Paper)
n1L+ n1H x 256
— 110 —
360)
Black Mark Paper
Label Paper
n2L+n2Hx256
n1L+n1Hx256
n2L+n2Hx256
n1L+n1Hx256