Advertisement
As the sensor used is different in electrical characteristics, use the sensor after fully recognizing it.
* The voltage detection range of the board (between 2 and 3) is as follows:
0 to 0.4 V: With paper
1 V or more: Without paper
Detection status other than the above is out of warranty.
3.6. Connecting Winder
Connector used: CN6: B2B-XH-A (JST9
Set up the connection shown in the following figure.
Voltage for the winder motor is applied at the same timing as that for the motor for printer mechanism.
Printing deviation may be caused by the torque of winding.
Winder Connection
Example
Control Board
WINDER (AW-5)
Advertisement
