AEG LAVAMAT 50600 Operating Instructions Manual page 29

Fault
Water is leaking out
from under the
washing machine.
Fabric softener is not
added, compartment
À for fabric
softener is filled with
water.
Appliance does not
spin, water in the
drum.
Washing has not been
spun sufficiently, there
is water left in the
drum.
Door cannot be
opened.
The rinse water is
cloudy.
Possible cause
The inlet hose connection is
not tight.
The inlet hose has a leak.
The drain pump cover is not
tight.
Washing is caught in the
door.
Suction cap in the fabric
softener compartment is not
correctly fitted or is blocked.
RINSE HOLD selected.
SOAKING program is
terminated.
There is a kink in the outlet
hose.
Maximum pumping height
(drain height 1m from the
position of the machine) is
exceeded.
Drain pump is blocked.
The water drainage system is
blocked.
The door is locked due to
safety reasons
Probably caused by a
washing powder with a high
silicate content.
Troubleshooting
Remedy
Tighten the inlet hose
connection.
Check the inlet hose and if
necessary replace it.
Tighten cover by turning
clockwise.
Abort the program, remove
the washing caught in the
door, start a new program.
Clean the detergent
compartment, fit the suction
cap on firmly.
Deselect RINSE HOLD.
Pump out water and set the
main wash cycle as desired.
Eliminate the kink.
Please contact AEG Service
Force Centre, it has a retro-
kit available for pump
heights above 1m.
Switch off the machine and
pull the plug out of the
socket, clean the drain pump.
Clean the blockage.
After programm termination
wait for 2-3 minutes.
This does not affect the
rinse results. If necessary use
liquid detergent.
29