AEG 1600 User Information page 44

Problem
Water is running out
from under the wash-
ing machine.
Conditioner is not be-
ing rinsed in, and the
w
compartment for
additives is full of wa-
ter.
The washing is badly
creased.
The washing has not
been spun as dry as
usual.
The door cannot be
opened when the
washing machine is
switched on. The N
symbol is showing in
the display.
44
Possible cause
The threaded inlet hose fit-
ting is leaking.
The outlet hose is leaking.
The drain pump cover is not
closed properly.
Washing has been trapped in
the door.
The emergency emptying
hose is not closed properly or
is leaking.
The conditioner insert is not
correctly set into the addi-
tive compartment or is
clogged.
Too much washing was prob-
ably loaded.
The washing was not able to
be distributed evenly in the
drum prior to spinning.
The door is looked for rea-
sons related to safety.
The washing machine is in
stand-by mode.
Remedy
Screw the inlet hose in
firmly.
Check the outlet hose and
replace if necessary.
Close the cover properly.
Cancel the programme and
free the washing from the
door. Restart the programme.
Close the emergency empty-
ing hose properly (see sec-
tion "Carrying out an
emergency emptying proce-
dure"). If the emergency
emptying hose is leaking, call
Service Force.
Clean the detergent drawer,
insert the conditioner insert
firmly.
Observe maximum load sizes
(see chapter "Consumption
values and load sizes"). Select
the EASY IRON programme
for easy-care items.
Always load the drum as full
as possible with a
combination of large and
small items.
Wait until the O symbol ap-
pears.
Press any button.