Answers And Explanations - HP Kayak XU 04xx User Manual

Answers and Explanations

Answers and Explanations
1 Can a 512 MB registered ECC memory module be mixed with a
unbuffered ECC SDRAM memory?
b No, it cannot. Registered and unbuffered memory modules are not
compatible.
2 Can a maximum of 1 GB of unbuffered ECC SDRAM memory modules
be installed on a HP Kayak XU Series 0441 PC Workstation?
a Yes, by installing 4 x 256 MB of unbuffered memory modules.
3 How can you distinguish the difference between the HP Kayak XU
model Series 0441, and the previous HP Kayak XU models
Series 0301 and Series 0303?
b The HP Kayak XU Series 0441 PC Workstation package is 8 cm
higher than the standard Kayak XU package.
This is to house the reinforced processor cage to hold in place the
Pentium II Xeon processors. The power supply unit in now located at
the bottom of the computer.
c Check the label on the side of the computer.
This label will indicate "Series 0441".
4 A single processor system has been upgraded to a dual processor
system. Is it necessary to install a VRM in the vacant VRM slot?
b Yes, it is.
5 To run the MaxiLife diagnostics program, does the computer need to
be powered on?
b No, it doesn't. The HP MaxiLife is always running and continuously
monitors the state of the LCD buttons. (The power cable must always
be connected.)
6 Can I install a single Pentium II Xeon processor in the DUAL PROC
processor slot?
b No, you cannot. Because the VRM installed in the VRM socket 2 can
only be recognized and configured by a Pentium II Xeon processor
installed in the BOOT PROC processor slot.
32