HP Kayak XA 05xx Manual page 30

Complete the Questionnaire to Check Your Understanding
5 Can I install unbuffered ECC SDRAM memory modules running at
66 MHz on a 100 MHz Front Side Bus?
a Yes, you can. The 100 MHz FSB supports unbuffered ECC SDRAM
memory modules running at 66 MHz and 100 MHz.
b No, you cannot. Unbuffered ECC SDRAM memory modules running at
66 MHz are not supported on a 100 MHz FSB.
6 How do I identify whether an HP Kayak XA Series 0503 and 0541 PC
Workstation has a Matrox Millennium G200 video board or an Elsa
GLoria Synergy+?
a Check the support label located at the back of the box on the right-
hand-side.
b Check the part number on the back of the box.
c Check the rear panel on the video board.
7 On the HP Kayak XA Series 0503 and 0541 PC Workstations, a single
processor system has been upgraded to a dual processor system. Is it
necessary to install a VRM?
a Yes, it is. Each processor must be accompanied with a VRM.
b No, it isn't. On the HP Kayak XA Series 0503 and 0541 PC
Workstations, the Pentium II Deschutes Slot 1 processors include an
integrated heatsink, and level-1 and level-2 cache memory. Therefore,
VRMs are not required.
c The HP Kayak XA Series 0503 and 0541 have only one processor slot,
and the VRM is built into the system board. Therefore, it is not possible
to upgrade to a dual processor system nor install a VRM.
8 To run the MaxiLife diagnostics program, does the computer need to
be powered on?
a No, it doesn't. As long as a power cable is connected, HP MaxiLife can
be started, and the diagnostics program run to check the various
system components.
b Yes, it does. This can be easily checked, because the LCD status panel
will be blank.
c No, it doesn't. Even with the power cable disconnected, MaxiLife runs
continuously and monitors the state of the various system
components.
30