Manual Storing Of Station Presets - Alpine TDA-7547E Owner's Manual

1
D.A.P.
M.I.X.
B. SKIP
18
1
1 2
MONO
5
4
RPT SCAN
Radio Operation
Manual Storing of Station
Presets
1. Select the radio band and tune in a desired
radio station you wish to store in the preset
memory.
2. Make sure that the Function indicator is
illuminated. Press and hold any one of the
Preset buttons (1 through 6) for at least 2
seconds. The frequency display will begin to
3
blink.
3. Press the preset button into which you wish
6
to store the station while the frequency
display is blinking (within 5 seconds).
The display stops blinking once the station
has been memorized. The display shows the
band, preset No. with a triangle (9) and
station frequency memorized.
4. Repeat the procedure to store up to 5 other
stations onto the same band.
To use this procedure for other bands, simply
select the band desired and repeat the
procedure.
A total of 24 stations can be stored in the preset
memory (6 stations for each band; FM1, FM2,
AM and D.A.P.).
Note: If you store a station in a preset memory
which already has a station, the current
station will be cleared and replaced with
the new station.
English