Routine Cleaning/Maintenance; Softened Water And/Or Decaffeinated Coffee - Bunn A10 Installation & Operating Manual

Rinsing the brew funnel and decanter after each use
is the only routine cleaning required. Occasionally, wipe
the outside of the brewer including the area above the
funnel with a damp cloth. (The brew funnel, hot water
funnel and decanter are top rack dishwasher safe.)
Using a phillips screw driver, periodically tighten the screw in the handle.
Periodically, you should delime the brewer to clear any deposits that may have
accumulated due to impurities in the water source.
1) Unscrew the sprayhead with your fingertips and set
it aside.
2) Insert all but two inches of the flexible deliming spring
probe (supplied) through the sprayhead opening.
3) Slide the tool in and out five or six times to loosen
mineral deposits collected in the sprayhead tube.
Remove it and set it aside.
4) Check the holes in the sprayhead for mineral deposits.
These may be cleared by using a toothpick. Rinse the
sprayhead with water before reinstalling.
5) Plug in the brewer and allow the water in the tank
to reheat before using the brewer. The frequency
of deliming depends on the mineral content of your
water.

SOFTENED WATER and/or DECAFFEINATED COFFEE

Bunn coffee brewers will brew a perfect decanter of coffee when used with
®
unsoftened tap water and regular coffee. If there's a noticeable difference when us-
ing softened water and/or decaffeinated coffee, telephone or write us to request a
special sprayhead and use a coarser grind of coffee.
Install a water conditioner if your water contains excessive amounts of sediment,
taste, or odors.
ROUTINE CLEANING
HANDLE MAINTENANCE
DELIMING
WATER QUALITY
12
P2083
P2084
P2085
43422.1 010311