Water Drainage - Zanussi FLS 879 C Instruction Booklet

Water drainage

If you intend the drain hose from the machine to empty
into a sink, make sure that the sink is empty and that the
plug hole is not blocked.
Place the drain hose in the sink with the aid of the bent
piece delivered separately.
The bent piece has to be entered into the tube´s mouth
in order to assure the support.. Aforesaid piece allows
the hose to be fixed to the wall by means of an opening
on the upper part and that way the hose does not move
and its falling is avoided
P0022
If the machine is permanently plumbed in, hook the end
of the hose into a standpipe installed for the purpose.
The standpipe must have an internal diameter of at least
40mm in order that there is an air gap between the drain
hose and the standpipe. Make sure, that it is designed in
such a way, that the end of the drain hose cannot be
covered with water.
Whether discharging into a sink or a standpipe check
that the end of the drain hose is neither too high nor too
low. The top of the curve in the hose's end should be no
3 pin
more than 90 cm, and no less than 60 cm above floor
level.
P1039
Should a prolongation of the drain hose be unavoidable
this must never surpass 1.5 m and must be of the same
diameter as the original hose
Important
Before connecting up the machine to new pipework or
to pipework that has not been used for some time, run
off a reasonable amount of water to flush out any debris
that may have collected in the pipes.
20