Table of Contents
Advertisement
Motion detection notification settings are made in Camera Server Properties of MV Manager (see p.
102) and Monitoring Screen Properties of MV Station (see. p. 108).
c
If a camera registered on the screen was restarted while monitoring in MV Station was
in progress, the screen needs to be selected again. If this is not done, the notification of
Note
motion detection event will no longer occur.
Notification of motion detection while Video Relay is in progress
If you receive notification of motion detection while Video Relay is in progress,
actions vary depending on the Camera Control Right settings.
Notification of motion detection in the
Camera 1 image
• Motion detection icon displayed
on the camera tree or camera
list changes when motion
d e t e c t i o n n o t i f i c a t i o n i s
received.
• A sound can be generated
when motion detection has
been notified (see p. 108).
If the "Display the corresponding video
when motion detection is enabled" box
is not selected (see p. 104), the camera
in which the motion was detected
displays the video. As other viewers
cannot obtain the camera control
privileges, the display either stays as a
still picture, or nothing is displayed.
This is because the motion detection
obtains the camera control privileges
at a higher priority level than MV Level
(see p. 105).
Camera 1 image be-
comes video display
and the title flashes
C a m e r a c o n t r o l
privileges cannot be
obtained with other
viewers
7
81
Advertisement
Table of Contents
