Connector Pinouts - RME Audio Hammerfall HDSP 9632 User Manual

34.2 Connector Pinouts

TRS jacks of analog input / output
The stereo ¼" TRS jacks of the analog inputs and outputs are wired according to international
standards:
Tip = + (hot) Ring = – (cold)
The servo balanced input and output circuitry allows to use monaural TS jacks (unbalanced)
with no loss in level. This is the same as when using a TRS-jack with ring connected to ground.
TRS Phones jack
The analog monitor output on the front is
accessible through a stereo ¼" TRS jack.
This allows a direct connection of head-
phones. In case the output should oper-
ate as Line output, an adapter TRS plug
to RCA phono plugs, or TRS plug to TS
plugs is required.
The pin assignment follows international
standards. The left channel is connected
to the tip, the right channel to the ring of
the TRS jack/plug.
Pin assignment of the 9-pin D-type connector, breakout cable SPDIF / AES
Note: The digital breakout cable is identical to the one used in the DIGI96 series.
Pin Name
1 GND
2 SPDIF Out +
3 SPDIF In +
Pin assignment of the 15-pin D-type connector and analog XLR breakout cable
Pin Name
1 Line In Left -
2 Line In Right +
3 Line Out Right +
4 MIDI Out (5)
5 MIDI In (4)
Pin assignment of the analog RCA/phono breakout cable
Pin Name
1 GND/Shell
2 Line In Right +
3 Line Out Right +
4 MIDI Out (5)
5 MIDI In (4)
86
Sleeve = GND
Pin Name
4 AES Out +
5 AES In +
6 SPDIF Out -
Pin Name
6 Line In Left +
7 Line Out Left -
8 Line Out Right - 13
9 GND/Shell
10 MIDI In (5)
Pin Name
6 Line In Left +
7 n.c.
8 n.c.
9 GND/Shell
10 MIDI In (5)
User's Guide HDSP System HDSP 9632 © RME
Pin Name
7 SPDIF In -
8 AES Out -
9 AES In -
Pin Name
11 Line In Right -
12 Line Out Left +
Phones Left
14 Phones Right
15 MIDI Out (4)
Pin Name
11 GND/Shell
12 Line Out Left +
13 Phones Left
14 Phones Right
15 MIDI Out (4)