Word Clock; Word Clock Input And Output - RME Audio Hammerfall HDSP 9632 User Manual

26. Word Clock

26.1 Word Clock Input and Output (optional Word Clock Module)
SteadyClock guarantees an excellent performance in all clock modes. Based on the highly effi-
cient jitter suppression, the HDSP 9632 refreshes and cleans up any clock signal, and provides
it as reference clock at the BNC output (see section 33.7).
Input
The HDSP 9632's transformer isolated word clock input is active when Pref. Sync Ref in the
Settings dialog has been switched to Word Clock, the clock mode AutoSync has been acti-
vated, and a valid word clock signal is present. The signal at the BNC input can be Single, Dou-
ble or Quad Speed, the HDSP 9632 automatically adapts to it. As soon as a valid signal is de-
tected, the green LED is lit, and the Settings dialog shows either Lock or Sync (see chapter
33.1).
Thanks to RME's Signal Adaptation Circuit, the word clock input still works correctly even with
heavily mis-shaped, dc-prone, too small or overshoot-prone signals. Thanks to automatic signal
centering, 300 mV (0.3V) input level are sufficient in principle. An additional hysteresis reduces
sensitivity to 1.0 V, so that over- and undershoots and high frequency disturbances don't cause
a wrong trigger.
The word clock input is shipped as high impedance type (not terminated). A push switch allows
to activate internal termination (75 Ohms). The switch is found beside the word clock input
socket. Use a small pencil or similar and carefully push the blue switch so that it snaps into its
lock position. The yellow LED will be lit when termination is active. Another push will release it
again and de-activate the termination.
Output
The word clock output of the HDSP 9632 is constantly active, providing the current sample fre-
quency as word clock signal. As a result, in Master mode the provided word clock is defined by
the currently used software. In Slave mode the provided frequency is identical to the one pre-
sent at the currently chosen clock input. When the current clock signal fails, the HDSP 9632
switches to Master mode and adjusts itself to the next, best matching frequency (44.1 kHz, 48
kHz etc.).
Selecting Single Speed in the Settings dialog (Word Clock Out) causes the output signal to
always stay within the range of 32 kHz to 48 kHz. So at 96 kHz and 192 kHz sample rate, the
output word clock is 48 kHz.
The received word clock signal can be distributed to other devices by using the word clock out-
put. With this the usual T-adapter can be avoided, and the HDSP 9632 operates as Signal Re-
fresher. This kind of operation is highly recommended, because
•
input and output are phase-locked and in phase (0°) to each other
•
SteadyClock removes nearly all jitter from the input signal
•
the exceptional input (1 Vpp sensitivity instead of the usual 2.5 Vpp, dc cut, Signal Adapta-
tion Circuit) plus SteadyClock guarantee a secure function even with highly critical word
clock signals
•
the Word Clock Module provides two word clock outputs with separated driver stages
Thanks to a low impedance, but short circuit proof output, the HDSP 9632 delivers 4 Vpp to 75
Ohms. For wrong termination with 2 x 75 Ohms (37.5 Ohms), there are still 3.3 Vpp fed into the
network – per output!
50
User's Guide HDSP System HDSP 9632 © RME