Advertisement
<Note>: Depending on a CD-R/RW drive,
the following screen may pop up when en-
tering the USB HOST menu selection screen.
While this pop-up screen is shown, the inter-
nal operation between the MR-8HD and the
CD-R/RW drive is being executed. The pop-
up screen will disappear after about ten sec-
onds. After the screen disappears, you can
select the USB HOST menu.
<Note>: If "Not Mounted" is shown at the bot-
tom of the screen when selecting the USB
HOST menu using the [MENU] dial, the MR-
8HD is not correctly connected to the CD-R/
RW drive.
If you press the [ENTER] key in this condi-
tion, "Warning: Not Mounted!" is popped up.
In this case, disconnect and then connect the
USB cable while the MR-8HD stops access-
ing to the internal hard drive or the external
CD-R/RW drive. Then confirm that "Not
Mounted" is not shown on the USB HOST
menu selection screen, and press the [EN-
TER] key.
4)
Use the [MENU] dial to select "CD Burn>"
and press the [ENTER] key.
The display changes to show the screen for
selecting a desired stereo WAV file from the "2 MIX"
folder of the currently loaded song.
The following (bottom) shows a screen example
where only one stereo WAV file exists in the "2 MIX"
folder.
<Note>: The following shows a screen ex-
ample where multiple stereo WAV files
exist in the "2 MIX" folder of the currently
loaded song.
5)
Use the [MENU] dial to select the desired
WAV file and press the [ENTER] key.
The MR-8HD starts writing to the CD-R/RW disc,
while the display changes to show the following
screen.
While the MR-8HD is writing to the disc, "Writing..."
is shown and the "ACC" flashes on the screen.
The access indicator on the CD-R/RW drive will
also flash. In such a condition, do not turn off the
power or press the eject key of the drive.
Also note that all of the MR-8HD keys are disabled
while the MR-8HD is writing to the disc.
When the MR-8HD finishes writing to the disc, it
stops disc access and the display changes to show
the following screen.
6)
Press the [ENTER] key.
The display returns to show the USB HOST menu
selection screen, where "CD Burn>" is highlighted.
If you write more than one stereo WAV file to
the disc, execute steps 4 through 6 above re-
peatedly and go to step 7 for finalizing the disc.
You can view the TOC information after carry-
ing out "CD Burn". See "Viewing TOC" on the
next page for details.
7)
Use the [MENU] dial to select
"CD Finalize>" and press the [ENTER] key.
The display changes to show the confirmation
screen for finalizing, where "<<Back" is highlighted.
5
Advertisement
