Parts Description; Main Printing Unit; Led Lamp - Brother P-TOUCH QL-560 Setup & Operation Manual

2 Parts Description

Main Printing Unit

Front
DK Roll compartment cover
FEED button
CUT button

LED lamp

ON/OFF button
Do not connect the QL-560 to your personal computer until directed to do so when
installing the printer driver.
LED Lamp
LED lamp on the QL-560 indicates the current operating condition.
Lamp
Not lit
Lit
Flashing fast
Flashing slow
Turns off after flashing
fast ten times
Power is OFF.
Power is ON.
(Normally lit while power is on, the LED flashes during cleaning or if an
error has occurred.)
Indicates one of the following errors.
• Cutter error
• Label sensor error
(DK Roll not installed correctly, end of DK Roll, or label jam)
• DK Roll compartment cover is open during operation
• Incorrect DK Roll installed
• No DK Roll installed
Cooling
(Waiting for temperature of print head to lower)
System error
Turn the QL-560 off and then on again.
If this error re-occurs, contact the retail outlet where the QL-560 was
purchased or your local authorized service center.
Rear
Condition
Power cord
USB port
9
STEP
1
STEP
2
STEP
3
STEP
4