Table of Contents
Advertisement
Align the triangular mark on the lock release lever with that on the toner
cartridge.
8
Close the toner cover.
IMPORTANT
•
•
NOTE
104
*Figure from the above
If you cannot close the toner cover, check if the toner cartridges are installed
properly. If you try to close the toner cover forcefully, this may result in damage to
the printer or toner cartridges.
Do not leave the toner cover open for a long time after installing the toner cartridge.
After the installation of the toner cartridges, it takes a few seconds until the
message <
Replacement Required" (in case of LBP5600SE) disappears. If the message does
not disappear, remove the replaced toner cartridge, hold the toner cartridge so that
its tab is at the bottom, shake the cartridge up and down forcefully again to evenly
distribute the toner inside the cartridge, and then install the toner cartridge.
Align with this part
> (in case of LBP5900SE) or "Toner Cartridge
Advertisement
Table of Contents
