Canon NP6045 Service Manual page 576

CHAPTER 10 TROUBLESHOOTING
Sorter Alarm Code
Tray Alarm Code
Display code Display code
02 Overstacking Overstacking
Stapler Alarm Code
Display code
01 Staple down
02 Staple jam
03 Stapler safety
mechanism ON
05 Stapling capacity
06 Stapling full
07 Different paper sizes
09 Paper in bin
0A No staple
RDF Alarm Code
Display code
01 Re-circulating bar idle
rotation
03 Pick-up separation
failure
05 Original over stopper
plate
11 Different number of orig-
inals after jam recovery
12 Wrong number of
originals
13 Original forced off
14 Original size error
15 Mixed original sizes in
image composition
10-150
COPYRIGHT © 1997 CANON INC.
Alarm Alarm
Remove all copy paper from the bin. Remove all copy paper from the bin.
Table 10-705
Alarm
Run a self check. (Done if the results are good.)
Open the front door, remove all staple jams, and
close the front door.
Open the front door, remove all jams, and close the
front door.
Remove all copy paper from the bin.
Remove all copy paper from the bin.
Remove all copy paper from the bin.
Remove all copy paper from the bin.
Set a new staple cartridge.
Table 10-706
Alarm RDF operation
Stops
Stops
Stops
Stops
Stops at
100th original
Stops
Stops
Stops
Table 10-707
Resetting Resetting
Resetting
Turn ON/OFF the original sensor (S1).
Turn ON/OFF the original sensor (S1).
Turn ON/OFF the original sensor (S1),
and open/close the RDF.
Turn ON/OFF the original sensor (S1).
Turn ON/OFF the original sensor (S1),
and open/close the RDF.
Turn ON/OFF the original sensor (S1),
and open/close the RDF.
Turn ON/OFF the original sensor (S1),
and open/close the RDF.
Turn ON/OFF the original sensor (S1),
and open/close the RDF.
CANON NP6045 REV. 1 MAR. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
Resetting