46
IBM IntelliStation M Pro Type 9229: User's Guide
Drive retainer clip
Drive retainer clip
release tab
b. Install the blue drive retainer clip into the screw holes on the side of the
drive (with the blue side of the clip facing outward).
Drive retainer clip
c. If you are installing a 5.25 in. drive in bay 2, slide the drive into the front of
the bay until it snaps in place. If you are installing a 3.5 in. drive in bay 2,
attach the 5.25 in. conversion kit and push the drive into the drive bay until it
snaps in place.
d. Determine whether the drive is a IDE, SATA, or SAS device; then, connect
one end of the applicable signal cable into the back of the drive and make
sure that the other end of this cable is connected into the applicable IDE,
SATA, or SAS connector.