Auto Tuning - Panasonic Viera UT50A series Operating Instructions Manual

Auto Tuning

Search and store TV channels automatically.
●
These steps are not necessary if the setup has been completed by your local dealer.
●
Please complete connections (p. 13 - 15) and settings (if necessary) of the connected equipment before starting Auto
Tuning. For details of settings for the connected equipment, read the manual of the equipment.
16
Plug the TV into mains socket and switch on
1
(p.11, 14)
● Takes a few seconds to be displayed.
● If the red LED shows on the TV, press the Standby On / Off switch on the
remote control.
Select your area
2
Select State / Territory
New South Wales / Australian Capital Territory
Victoria
Queensland
South Australia
Western Australia
Northern Territory
Tasmania
Select the mode to tune
3
TV Signal Selection
Digital TV
Analogue TV
Start Auto Tuning
Select [Start Auto Tuning]
4
TV Signal Selection
Digital TV
Analogue TV
Start Auto Tuning
●
Auto Tuning will start to search for TV channels and store them.
The stored channels and sorted channel order vary depending on the area,
broadcasting system and conditions of signal reception.
Auto Tuning
Digital TV Scan CH 6
CH 0
Analogue TV Scan
This will take about 6 minutes.
RF Ch Channel Name
62 CBBC Channel
62 BBC Radio Wales
62 E4
62 Cartoon Nwk
29
33
Digital TV: 4 Analogue TV: 2
Searching
Setup the network connection
5
Setup the network connection to enable the network service functions such as VIERA
Connect, etc. (p. 19, 75).
●
To setup the wireless connection, the Wireless Adaptor (optional accessory) is
required. Please note that this TV does not support wireless public access points.
●
Ensure the network connections (p. 15) and network environment are completed
before starting setup.
Select the network type
Network Setup
Select Wired or Wireless
Wired Wireless
/
: tune (search for the available channels)
: skip tuning
69
75
Type Quality
Digital TV 10
Digital TV 10
Digital TV 10
Digital TV 10
Analogue TV -
Analogue TV -
[Wired]
[Wireless]
Set later
●
To setup later on or skip this step
Select [Set later] or
select
set
select
tune / skip tuning
select
access
"Wired connection" (p. 15)
"Wireless connection"
(p. 15)
select
access