Brother P-touch BB4 Service Manual page 40

4) Counterclockwise turn the select dial slowly and check that the correct dial
position number will be displayed.
NOTE: Do not turn the select dial quickly or clockwise. Doing so cannot check the
dial operation correctly. If the select dial is set to any wrong position, "X" will
display as shown below. In the sample below, the select dial should be set to Dial
position 2 but now it is set to any other position. Turn the select dial to Dial
position 2 clockwise or counterclockwise.
5) After checking dial position 31, turn the select dial to the next position (Dial
position 0), then "OK" will appear and "OK" will be printed.
After printing is complete, the screen will automatically change from "OK" to
"CUT."
6) Press the cutter lever and cut the tape.
CUT submode (Dial position 3 and Enter key*)
(*In any other submode, setting the select dial to Dial position 3 and pressing the Enter key
will jump to CUT submode, except during checking in DIAL submode.)
The cutter operation may be checked in any other submode, so you may skip this
CUT submode and proceed to PRINT1 submode. To do so, turn the select dial to Dial
position 4 and press the Enter key.
1) Press the Enter key.
While displaying the following, the machine will feed tape.
II - 27