Mazda 2 Owner's Manual page 84

Mazda2_8CL7-EA-12H_Edition1 Page84
Monday, June 18 2012 1:48 PM
Knowing Your Mazda
Doors and Locks
Power window system initialization
procedure
If the battery was disconnected during
vehicle maintenance, or for other reasons
(such as a switch continues to be operated
after the window is fully open/closed), the
window will not fully open and close
automatically. Carry out the following
procedure to resume operation:
1. Switch the ignition ON.
2. Press the switch and fully open the
window.
3. Pull up the switch to fully close the
window and continue holding the
switch for about 2 seconds after the
window fully closes.
Two-step down function
With the window completely closed, press
the switch lightly and the window will
open and stop about 3 cm (1 in) from the
top.
If you continue to press and hold the
switch, the window will resume opening
all the way.
NOTE
Pressing the power window switch once
l
when the window is fully closed will only
open it about 3 cm (1 in) to allow
convenient ventilation of the cabin.
The range in which the window opens can
l
be changed.
Refer to Personalization Features on page
10-8.
The two-step down function can be
l
canceled.
Refer to Personalization Features on page
10-8.
3-16
Form No.8CL7-EA-12H
Black plate (84,1)
Jam-safe window
If a person's hands, head or an object
blocks the window during the auto-
closing operation, the window will stop
and open halfway.
WARNING
Make sure nothing blocks the window
just before it reaches the fully closed
position or while holding up the power
window switch:
Blocking the power window just
before it reaches the fully closed
position or while holding up the
power window switch is dangerous.
In this case, the jam-safe function
cannot prevent the window from
closing all the way. If fingers are
caught, serious injuries could occur.
NOTE
Depending on driving conditions, a closing
power window could stop and start opening
when the window feels a shock that is similar
to something blocking it.
In the event the jam-safe function activates and
the power window cannot be closed
automatically, pull and hold the switch and the
window will close.
Engine-off power window operation
The power window can be operated for
about 40 seconds after the ignition is
switched from ON to ACC or OFF with
all doors closed. If any door is opened, the
power window will be inoperable.
NOTE
For engine-off operation of the power
l
window, the switch must be held up firmly
throughout window closure because the
auto-closing function will be inoperable.
The two-step down function is inoperable
l
during engine-off operation.