Programming The Controllers; Introduction To Programming Options; The Fader And Rotary Dials - M-Audio Ozonic User Manual

Programming the Controllers

< Introduction to Programming Options
Each of the Ozonic's controllers can send MIDI CC, RPN/NRPN, GM 1&2, and SysEx messages. They can also be assigned to individual MIDI
channels.
MIDI CC (continuous controller) numbers are part of the standard MIDI specifications and are typically used to control the real-time changing
of parameters in musical equipment. For a complete list of standard MIDI controller numbers from 0 to 131, please see Appendix E.
Any of the real-time controllers on the keyboard can be assigned to a MIDI CC number; the assignable buttons and pedals have slightly
different options from the faders or rotary controllers.
The two charts show the transmit messages that can be programmed for each of the knobs, faders, and assignable buttons.
Please pay extra attention to the differences between programming the faders or knobs and programming the buttons.
< The Fader and Rotary Dials:
MIDI CC Description
0-119 Standard MIDI CC's
120-127 Channel Mode Messages
128 Pitch Bend Sensitivity
129 Channel Fine Tune
130 Channel Coarse Tune
131 Channel Pressure
132 RPN coarse
133 RPN fine
134 NRPN coarse
135 NRPN fine
136 Master Volume GM*
137 Master Pan GM*
138 Master Coarse Tune GM*
139 Master Fine Tune GM*
140 Chorus Mod rate GM2*
141 Chorus Mod Depth GM2*
142 Feedback GM2*
143 Send to Reverb GM2*
144 Pitch Bend
OFF Controller Off***
Data 2 Data 3
Max Min
Max Min
- -
- -
- -
- -
RPN LSB RPN MSB
RPN LSB RPN MSB
NRPN LSB NRPN MSB
NRPN LSB NRPN MSB
- -
- -
- -
- -
- -
- -
- -
- -
- -
- -
22