Bradford White EVERHOT TG-150E-N(X Installation And Operation Instruction Manual page 41

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing
A. This water heater does not have a
pilot. It is equipped with a direct
ignition device, which automatically
lights the burner. Do not try to light
the burner by hand.
B. BEFORE OPERATING: Smell all
around the appliance area for gas.
Be sure to smell next to the floor,
because some gas is heavier than
air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electric switch; do
not use any phone in your building.
1. STOP! Read the safety information
above before proceeding.
2. Set the thermostat to the lowest
setting.
3. Turn off all power to the electrical
appliance.
4. This water heater does not have a
pilot. It is equipped with a direct
ignition device, which automatically
lights the burner. Do not try to light
the burner by hand.
5. Turn the manual valve located at the
gas inlet of the appliance clockwise
to "OFF" (See Figure 16).
1. Set the thermostat to the lowest
setting.
2. Turn off all electric power to the
appliance if service is to be
performed.
LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE OPERATING
property damage, personal injury or loss of life.
OPERATION INSTRUCTIONS
TO TURN OFF GAS TO THE APPLIANCE
Figure 16. Manual Gas Valve.

Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.

If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to operate the remote control
keypad. Never use tools. If the remote keypad
doesn't work, do not try to repair it, call a qualified
service technician. Forced or improper repair
may result in a fire or explosion.
D. Do not use this water heater if any part has been
under water. Immediately call a qualified service
technician to inspect the water heater and to
replace any part of the control system and any
gas control which has been under water.
6. Wait (5) minutes to clear out any gas. If you
then smell gas, STOP! Follow "B" in the safety
information above on this label. If you don't smell
gas, go to next step.
7. Turn the manual valve located at the gas inlet of
appliance counterclockwise
Figure 16).
8. Turn on all electric power to the appliance.
9. Set the thermostat to desired setting.
10. If the appliance will not operate, Follow the
instructions "To Turn Off Gas To Appliance" and
call your service technician or gas supplier.
3. Turn the manual valve at gas inlet of appliance
clockwise to "OFF" (See Figure 16).
41
to "ON" (See