Microphone Placement; Operating The Battery Powered Headset; Power Switch; Control Module Mounting Clip - Bose Aviation Headset X Owner's Manual

Using the Bose

Microphone placement

Clear communications depend on proper microphone placement.
Follow these three steps for proper placement:
1. Identify the left and right earcups and put on the headset.
2. While holding the boom pivot in place, grasp the boom with your
Note: Make sure the microphone is positioned with its label side
closest to the mouth. Do not purse your lips. The microphone should sit
slightly off center, but right at the opening of your mouth.
3. Once the microphone is in place, make sure the plastic housing
Figure 4
Microphone placement

Operating the battery powered headset

Power switch

Turn on active noise reduction by setting the power switch to ON. See
Figure 5 for details.
Note: If you are connecting the headset to a newly installed aircraft
powered system, remove the headset from your head before turning it
on for the first time, in case of high-volume output.

Control module mounting clip

The control module mounting clip permits attachment to the user's
clothing, safety harness, or aircraft door pockets. Do not attempt to
clip onto surfaces greater than
14
pad to the face of the clip for attachment to other surfaces.
®
Aviation Headset X
fingers and move the microphone housing to your mouth.
with the printing is perpendicular to the lips. For clearest communi-
cations, make sure the microphone is as close as possible to your
lips – you should feel the windscreen brushing your lips as you
speak.
1 / -inch thick. You may attach a Velcro
4