Air Duct; Removing The Driven Pulley Shaft Bearing - PIAGGIO Fly 150 4T Workshop Manual

Fly 125 - 150 4T

Air duct

- Unscrew the Torx screws fixing the air manifold
bulkhead and remove the bulkhead.
- Remove the 3 screws, then take out the manifold
as well as the filter.

Removing the driven pulley shaft bearing

- Remove the clip from the inside of the cover.
- Use the specific tools to remove the bearing from
the crankcase.
CAUTION
USE AN APPROPRIATE REST SURFACE TO
AVOID DAMAGING THE COVER PAINT.
Specific tooling
020376Y Adaptor handle
020375Y Adaptor 28 x 30 mm
Engine
ENG - 85