Installing Software - 3Com 3C6090 - NETBuilder II Dual Processor Engine Router User Manual

Installing Software

3 Verify that configurable parameters of your console match the configuration
settings of the Console port specified in Table 1-1.
Table 1-1 Console Port Configuration Settings
Characteristic
Baud rate
Databits
Parity
Stop bits
DTR
Duplex
Echo
Flow control
4 Turn on the console.
If you have the software from 3Com preinstalled on a flash memory card,
remove the flash memory drive cover if present and insert the card into drive A,
the top flash memory drive. The default boot and configuration file paths are
set to a directory on drive A.
See the next section to remove and reinstall the flash memory drive cover.
Setting
9600
8
None
1
Ignored
Full
Off
X-on/X-off
Installing Software 1-7