Panasonic Viera DT50A series Operating Instructions Manual page 52

Set all channels automatically [Auto Tuning]
Automatically retune all channels received in the area.
1
Start Auto Tuning
Example: Digital TV
Digital TV Auto Tuning
All digital TV tuning data will be erased
●
All the previous tuning settings are erased.
●
When the operation is completed, the channel at the lowest position will be displayed.
●
Search begins in the order from the lower channels to the higher channels.
●
If tuning has not been done completely
Set Digital TV channel manually [Manual Tuning]
Normally use [Auto Tuning] or [Update Channel List] to retune Digital TV channels.
If tuning has not been done completely or for adjusting the direction of the aerial or dish, use this function.
● All channels found will be added to the Channel List.
Digital TV Manual Tuning
Physical Channel [CH21]
Signal Quality 0
0
Signal Strength
No. Channel Name Type
Digital TV: 0
Set Analogue TV channel manually [Manual Tuning]
Set Analogue TV channel manually after Auto Tuning.
●
If a VCR is connected only with the RF cable, select channel position [0].
Analogue TV Manual Tuning
0
0
Manual Tuning
Store
1
Select the channel position
3
Search
52
2
Example: Digital TV
Digital TV Auto Tuning
Scan
This will take about 3 minutes.
RF Ch
Digital TV: 4
[Manual Tuning] (see below)
select physical channel
474.00 MHz
select offset
10
10
New
start tuning
CH 57
75
2
4
Settings are made automatically
CH 6
Channel Name Type
32 TV Fin land Digital TV 9
32 Boxer Navigator Digital TV 9
32 SVT HD Digital TV 9
Searching
Select the channel
Select [Store]
select
store
69
Quality
Y
li
S
S
A
U
●
●
●
E
F
1
2
3