Panasonic HC-X900 Operating Instructions Manual page 37

≥ Change the mode to
1 Set [QUICK START] to [ON].
2 Close the LCD monitor and retract the viewfinder.
/
HC-X900 HC-X900M
The status indicator A flashes green and the unit goes into Quick Start Standby Mode.
≥ The lens cover does not close.
3 Open the LCD monitor or extend the viewfinder.
/
HC-X900 HC-X900M
The status indicator A lights red and the unit is put into recording pause.
≥ Quick Start Standby Mode is cancelled if
j about 5 minutes elapsed
j mode is set to
≥ Depending on the recording conditions and menu settings, time for Quick Start may be
longer than 0.6 seconds.
≥ It may take some time for Automatic White Balance to adjust.
≥ In the Quick Start Mode, the zoom magnification becomes approx. 1k.
/
≥
HC-X900 HC-X900M
If [ECONOMY (BATT)] (l 36)/[ECONOMY (AC)] (l 36) is set to [ON] and the unit
automatically goes into Quick Start Standby Mode, close the LCD monitor and viewfinder
and then open the LCD monitor or extend the viewfinder again.
HC-X800
If [ECONOMY (BATT)] (l 36)/[ECONOMY (AC)] (l 36) is set to [ON] and the unit
automatically goes into Quick Start Standby Mode, close the LCD monitor and then open it
again.
≥ Turn the unit off using the power button.
/
≥
HC-X900 HC-X900M
Quick Start Standby Mode cannot be released by the remote control.
or .

- 37 -
HC-X800
HC-X800

