Before You Begin; Mounting System Components - Black Widow Security BW X-Z Series System Manual

VEHICLE SECURITY SYSTEM
Optional Remote Start Module and 2-way Transmitter Instructions Included
INSTALLATION INSTRUCTIONS
BEFORE INSTALLING THIS PRODUCT PLEASE READ
THE INSTALLATION DIRECTIONS THOROUGHLY!!

BEFORE YOU BEGIN

This system is compatible with electronic
fuel injected engines only! Not intended for
use with carbureted engines.
• This product must be installed by qualified
personnel according to these instructions and
and observing all safety features.
• Check to see if the vehicle is equipped with
any type of factory security system.
• Check to see if there is a pin switch for the
hood, if not one must be installed.
• Verify that the vehicle starts and idles
properly before beginning the installation.
• Always use a multi-meter to verify wiring.
• Before mounting the product, verify with the
customer the desired location for the valet
switch and LED.

MOUNTING SYSTEM COMPONENTS

Mounting Siren
Mount the siren in a suitable place under the
hood, away from hot and moving engine parts
such as manifolds, fan belts, etc. Make sure the
siren cannot be accessed from underneath the
vehicle or through the grill. Face the siren down
so that water cannot accumulate inside the
siren bell. Protect wires running through the
firewall using either tape or split loom tubing. If
a new hole is needed, protect the wire from
chaffing by installing a proper size grommet.
Mounting System Modules
Mount the security and optional remote start
module under the dash where it will be difficult
for a potential thief to locate them, and away
from moving parts such as brake pedals, etc.
Mounting LED
Mount the LED in an area that is easily seen
from outside either side of the vehicle. Consult
with the vehicle's owner to verify placement
before drilling.
Mounting Override Switch
Mount the override switch in an area that is not
easily seen yet within reach of the driver from
the seated position. Consult with the vehicle's
owner to verify placement before drilling.
Mounting Extended Range Receiver
Mount the extended range receiver (or
transceiver on 2-way equipped systems) to the
inside of the windshield using the supplied
double-sided tape.
location does not obscure the driver's view.
Mounting Shock Sensor
Mount the shock sensor to an under dash
brace or similar support structure using a tie-
wrap or the supplied double-sided tape. Higher
sensitivity may be found in some vehicles by tie-
wrapping the sensor to a wire loom.
12
Make sure the chosen