Black Widow BW 3750 Installation Manual

6r / 5-button series vehicle security system

Advertisement

Quick Links

6R / 5-BUTTON SERIES
VEHICLE SECURITY SYSTEM
Button
1
Button
3
Standard Features:
Two 5-Button Remote Transmitters
Status indicator (LED)
Valet / override switch
Multi-tone siren
Dual stage impact sensor
Remote panic
Remote chirp mute
Remote sensor bypass
Passive or active arming
Optional Features:
Flashing parking lights
Starter disable
Keyless entry
Remote trunk or hatch release
Illuminated entry
Hood and trunk protection
Remote auto start
Power window roll up
Glass break sensor
Microwave sensor
Note: Some features may require additional
parts and labor, and may not be appropriate for
certain vehicles. Consult your authorized dealer.

System Operation

ARMING OPERATION
Button
2
To arm the system press transmitter button 1:
Button
5
• The siren will chirp once.
• The parking lights will flash once.*
Button
4
• The doors will lock.*
• The LED will turn solid for 10 seconds
then start flashing slowly. After 10
seconds the system is armed.
After Arming, if the system detects a bad
sensor or an open zone, the siren will chirp
and the parking lights will flash 4 times to
indicate a zone is open. The system will
ignore that input, but keep all other areas
protected.
While Armed, the system will trigger if:
• The doors are opened.
• The shock sensor detects an impact.
• An optional sensor is disturbed.
• The hood or trunk is opened.
When triggered by the door or hood/trunk
input the siren will sound, the horn will
honk, and the parking lights will flash for 45
seconds. If triggered by a sensor, the alarm
cycle will last 30 seconds.
If the same input triggers the system 3 times
during a single arming cycle, the system will
bypass that input, keeping the other zones
protected, until the next time the system is
armed.
If the shock sensor detects a light impact to
the vehicle or an optional sensor is
disturbed, the system will chirp and the
parking lights will flash 5 times to warn away
the potential intruder.
*
Optional Feature
1

Advertisement

Table of Contents
loading

Summary of Contents for Black Widow BW 3750

  • Page 1: System Operation

    6R / 5-BUTTON SERIES VEHICLE SECURITY SYSTEM System Operation ARMING OPERATION Button Button To arm the system press transmitter button 1: Button • The siren will chirp once. • The parking lights will flash once.* Button Button • The doors will lock.* •...
  • Page 2: Auto Rearm

    PASSIVE ARMING TAMPER ALERT The passive arming feature allows the system If the alarm was triggered while away from to automatically arm after closing all doors. the vehicle, the siren will chirp 3 times and The Passive Arming feature requires the the parking lights will flash 3 times on ignition to have been on for at least 10 disarming for tamper indication.
  • Page 3 • The siren will sound. To enter or exit valet mode using the remote: • The parking lights will flash*. 1. Be sure the ignition key is off. Press button 1 to exit panic mode and rearm the system. Press button 2 to exit panic 2.
  • Page 4: Transmitter Functions

    Passive. When selected, the anti-carjacking Transmitter Functions with Shift Key feature will activate whenever a door is (Button 5) pressed 1 time: opened while the ignition is on. Press the Button 1 Silent Arm valet switch 3 times to deactive the Passive Button 2 Silent Disarm carjack feature.
  • Page 5: Installation Instructions

    INSTALLATION INSTRUCTIONS Before you begin the installation Mounting Shock Sensor Secure the shock sensor to the steering • Read the INSTRUCTIONS! column, thick wire harness or a dash brace, • Always use a multi-meter when verifying using a wire tie. Make sure that the vehicle wiring.
  • Page 6: Starter Defeat Connectors

    • GRAY WIRE - Auxiliary 1 output (+/–) • BLUE WIRE - Trunk/Hood trigger (-). 15A relay. Connect to an optional feature Connect the Blue wire to the trunk and/or such as trunk release, etc. optional hood pin switches.The switch must provide a ground output when opened.
  • Page 7 4-Pin White Connector A: Plug-in connector Entering Programming port for dual stage shock sensor. To enter System Programming: 4-Pin White Connector B: Plug-in connector 1. Turn on ignition. port for optional dual stage radar sensor. 2. Within 5 seconds, press valet switch 5 times.
  • Page 8 Programmable Features 11. Siren / Horn Chirps.When set for Horn Chirps the horn will honk when the alarm is 1. Arming Mode. Select between manual armed, disarmed, and triggered, allowing the arming (Active), automatic arming (Passive), siren to NOT be installed. Button 3 adds horn and automatic arming with chirps that chirps with the warn away feature as well.
  • Page 9 Programmable Features Step Function Button 1 (default) Button 2 Button 3 Button 4 1. Arming Mode Active Passive Passive w/count 2. Parking Light Output Flash twice 30 seconds 3. Auto Rearm Auto rearm Auto rearm w/lock 4. Arming Chirps Normal Silent 5.
  • Page 10: Door Lock Wiring Diagrams

    DOOR LOCK WIRING DIAGRAMS NEGATIVE PULSE LOCK SYSTEM POSITIVE PULSE LOCK SYSTEM ADDING ACTUATORS VACUUM LOCK SYSTEM REVERSE POLARITY LOCK SYSTEM...
  • Page 11: Optional Relay Wiring Diagrams

    OPTIONAL TWO-STEP UNLOCK WIRING DIAGRAMS TWO-STEP NEGATIVE PULSE TWO-STEP POSITIVE PULSE TWO-STEP REVERSE POLARITY TWO-STEP ADDING ACTUATORS OPTIONAL RELAY WIRING DIAGRAMS POSITIVE TRIGGER NEGATIVE TRIGGER TO WIRE TO WIRE IN VEHICLE IN VEHICLE (-) OUTPUT (-) OUTPUT FROM ALARM FROM ALARM +12V +12V...
  • Page 12: Wiring Diagram

    WIRING DIAGRAM JUMPER SETTINGS The polarity for the built-in parking light, dome light, and auxiliary relay is set by the placement of the jumper on the 3 pins next to each relay. The default settings are illustrated below. © 2004 64-37.50, 3/04 Rev.

Table of Contents