Table of Contents
Advertisement
Front Panel
1
2
STANDBY/ON
(*) The unit can also be turned on by pressing these buttons.
1.
STANDBY/ON
button
• Press to turn on the unit, or to turn the unit into the
standby mode. (To completely turn off the unit, you
must unplug the AC power cord.)
• Press and hold for 10 seconds to shut down the unit.
• This button lights up in red when the unit is in
standby mode and turns off when the power is on.
2.
STANDBY/ON indicator
• This indicator lights up in red when the power is in
the standby mode.
3.
Disc tray
• Place a disc after opening the disc tray.
4.
OPEN/CLOSE A button*
• Press to open or close the disc tray.
5.
Infrared sensor window
• Receive signals from your remote control so that you
can control the unit from a distance.
6.
Display
• Refer to "Front Panel Display" on page 10.
Rear Panel
1
1. AC power cord
• Connect to a standard AC outlet to supply power to
this unit.
• Unplug this cord from the AC outlet to completely
turn off the unit.
2. 5.1ch Audio Out jacks (SPEAKERS (4Ω))
• Use to connect supplied 5.1ch speakers.
3. HDMI OUT jack
• Use to connect to a display with an HDMI compatible
port with an HDMI cable.
4. AUDIO IN (AUX) jacks
• Use to connect an other device with audio out jack
with an audio cable.
5. FM ANT 75Ω jack
• Use to connect the supplied FM wire antenna.
EN
INTRODUCTION
3
4*
OPEN/CLOSE
2
SPEAKERS(4Ω)
SUB-
FRONT
REAR
FRONT
WOOFER
CENTER
5
6
7.
VOLUME K / L button
• Press to adjust the volume.
8.
STOP C button
• Press to stop playback.
9.
PLAY B button*
• Press to start or resume playback.
10. SOURCE button
• Press to switch the active source mode.
11. MP3 LINE-IN jack
• Use to connect your portable audio player with
3.5mm stereo audio cable.
12. SD CARD slot
• Insert an SD Memory Card and play back the
contents in it.
Note
• This unit will be turned into the standby mode
automatically after 25 minutes of no action.
3
4
HDMI OUT
AUDIO IN
AUX
6. DIGITAL AUDIO IN (Coaxial) jack
• Use to connect an other device with a digital audio
coaxial output jack with a digital audio coaxial cable.
7. COMPONENT VIDEO OUT jacks
• Use to connect a TV monitor with component video
inputs with a component video cable.
8. VIDEO OUT jack
• Use to connect a TV monitor, an AV receiver /
amplifier or other device with a video cable.
Note
• Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
• This unit does not have the RF modulator.
7
8
9* 10
VOLUME
STOP
PLAY
SOURCE
SD CARD
MP3 LINE-IN
12
11
5
6 7
DIGITAL
COMPONENT VIDEO OUT
FM
AUDIO IN
ANT
Pr
Y
75Ω
Pb
VIDEO OUT
8
EN
7
Advertisement
Table of Contents
