Installation; Preparing To Change Your Internet Adapter Settings; Preparing To Change Internet Adapter Settings - NETGEAR WNCE2001 - Ethernet to Wireless Adapter Workshop Manual

Installation

The Universal WiFi Internet Adapter (WNCE2001) Installation Guide included in the package,
explains how to install your Internet adapter. The steps are summarized in this section.
You use a computer to set up the Internet adapter. During setup, make sure that your
1.
computer is not connected to a router. You can restore the connection after the Internet
adapter installation is complete.
Disconnect the Ethernet cable from your computer if you use it for a wired network
•
connection.
If your computer is wirelessly connected to a network, stop your wireless connection.
•
Connect the Internet adapter.
2.
Use an Ethernet cable (included) to connect the Internet adapter to your computer.
•
Use either the USB power cable or the power adapter to provide power to the Internet
•
adapter. (See
Open your Internet browser. It automatically displays the setup page. Follow the instructions
3.
on the setup page.
Disconnect the Ethernet and USB cables from your computer.
4.
Connect the Internet adapter to your TV, Box, or Blu-ray player.
5.
If your device doesn't have a USB port, then use the power adapter cable that came with
your Internet adapter and plug it into an electrical outlet.
Congratulations! Your installation is complete. You can return your computer to its usual set
6.
up and begin using the Internet adapter.

Preparing to Change Your Internet Adapter Settings

If you want to change the settings for the Internet adapter after installation, then you need to
connect it to a computer while you are making changes.
Connect your Internet adapter to a computer with an Ethernet cable.
1.
Connect either the USB power cable or the power adapter cable that came in the product
2.
package to the rear panel of your Internet adapter.
6 | Chapter 1. Getting Started
Power Connection Options
Universal WiFi Internet Adapter WNCE2001
on page 5.)