Rf Block(C131A Only) - Panasonic BL-C111A - Network Camera - Pan Service Manual

BL-C111A /BL-C131A
4.2.

RF Block(C131A only)

• Antenna
• Receiver
The receiving signal from the antenna is input to the RFIC (IC601) after being passed through the Antenna Switch (IC502)
and amplified at LNA (Low Noise Amp).The RFIC (IC601) incorporates the LNA (Low Noise Amp), the Mixer for Frequency
Converter and the Synthesizer generating the Receiving Local Signal. At the RFIC (IC601), the input signal is separated into
the baseband signals of the In-Phase(RxI) and Quadrature (RxQ) to output.
The baseband signal is input to the CPU&MAC/BB/RFIC(IC601) and, after A/D conversion, the data are regenerated.
• Transmitter
The Data Frame (Data Packet) generated at the built-in MAC Part by the CPU&MAC/BB/RFIC (IC601) is converted to the RF
Signal of the transmitting frequency band.
After processing including impedance conversion, level adjustment and control of the unnecessary frequency component, it
is sent from the antenna through the Antenna Switch (IC502).
The RF Signal from the Power Amp (IC501) is fed back to the RFIC (IC601) after level detection. The gain is adjusted in the
RFIC (IC601) for a constant transmitter output level.
16