Preparation For Storage - Honda BF8A Owner's Manual

-
Preparation for storage
1. Disconnect the fuel line and install the cap on the engine fuel inlet.
Firmly close the fuel cap vent knob.
CAP
FUEL HOSE CONNECTOR
'\ . .
'\
-.._
qi!J-&
;:,z L -
\ r
?
FUEL INLET
2. Loosen the carburetor drain screw, and drain the gasoline into a
suitable container. After draining, tighten the drain screw.
B
l
Be careful not to spill fuel. Spilled fuel or fuel vapor may ignite. If
any fuel is spilled, make sure the area is dry before storing or
transporting the motor.
l
Do not smoke or allow flames or sparks where fuel is drained or
stored.
pziq
In cold weather, to prevent ice from forming inside the water pump,
raise the motor out of the water. Disengage the emergency stop
switch clip from the engine stop switch and pull the recoil starter
several times to flush out the water.
DRAIN SCREW
3.Tilt the outboard motor and remove the plug caps. Disengage the
emergency stop switch clip from the engine stop switch and pull the
recoil starter several times and completely drain the cooling water.
[NOTlCEI
If the outboard motor is put on its side immediately after stopping it
without completely draining the cooling water, water may enter the
engine from the exhaust port. Be sure to drain the cooling water
before putting the outboard motor on its side.
41