Fujitsu AWYZ14LBC Operating Manual page 6

Turn on the Power
Connect the Power Supply Plug (Fig. 1 H) to an electrical outlet;
in the case of a direct line connection, turn on the circuit breaker.
Load Batteries (LR03 × × × × × 2)
1 Press and slide the battery compartment lid on the re-
verse side to open it.
Slide in the direction of the arrow while pressing the
2 Insert batteries.
Be sure to align the battery polarities (+/-) correctly.
3 Close the battery compartment lid.
4 About the RESET (Fig.5 r) button
• If the Remote Controller is unable to func-
tion normally after the batteries are changed,
please press the RESET button (Fig.5 r).
• Press the RESET button (Fig.5 r) using a
ball-point pen or other such items with a
relatively sharp tip.
Set the Current Time
1 Press the CLOCK ADJUST button (Fig. 5 s)
Use the tip of a ball-point pen or other small object to press the button.
2 Use the /
the clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed,the time will be advanced/reversed in
one-minute steps.hold the buttons depressed to change the time quickly
in ten-minute steps.)
3 Press the SET button (Fig. 5 o).
This completes the time setting and starts the clock.
To Use the Remote Controller
G The Remote Controller must be pointed at signal receiver (Fig. 1 9) to operate
correctly.
G Operating Range: About 7 meters.
G When a signal is properly received by the air conditioner, a beeping sound will
be heard.
G If no beep is heard, press the Remote Controller button again.
Remote Controller Holder
Insert
Screws
1Mount the Holder. 2 Set the Romote Con-
troller.
En-5
RESET
botton
SET TIME buttons (Fig. 5 n)to adjust
Pull out
Press in
3To remove the Remote Con-
troller (when use hand).
CAUTION!
G Take care to prevent infants from
accidentally swallowing batteries.
G When not using the Remote Controller
for an extended period, remove the
batteries to avoid possible leakage and
damage to the unit.
G If leaking battery fluid comes in contact
with your skin, eyes, or mouth, immedi-
ately wash with copious amounts of
water, and consult your physician.
G Dead batteries should be removed
mark.
quickly and disposed of properly, either
by placing in a public battery collection
receptacle, or by returning to appropriate
authority.
G Do not attempt to recharge dry batteries.
G Please always press the RESET button
after changing batteries to avoid the
possibility of functional errors.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about one year
under normal use.
In any of the following situations, please
change your batteries.
• The Battery Indicator Display is shown
• No data transmission possible unless
close to Indoor Unit
• The Remote Controller is unable to
work properly