Fujitsu AWYZ14LBC Operating Manual page 19

3. Install the dust box onto the main unit, press the "MAINTENANCE / MANUAL AUTO" button, and then insert the air filter.
1. Install the dust box onto the main unit.
Make sure that the dust box's 2 yellow latches are
open.
Open the front panel and insert the dust box into the
unit until you hear it catch in place.
Remove
Insert the dust box fully and move the two latches on
either side outside to lock it in place.
Remove
"click"
G If the latches are locked while installing the dust box,
malfunctions may result and the dust box may fall out.
G During installation, make sure that you have a good
grip of the middle of the dust box and insert it soundly
in its place. Should there be any errors in installation,
the dust box may fall out and cause injury.
2. Insert the power supply line into its socket
and press the MAINTENANCE / MANUAL
AUTO button (Fig.3
Insert the power supply line into its socket.
Press the unit's "MAINTENANCE / MANUAL AUTO"
button.
Latch
Lock
Latch
Lock
).
*If the MAINTENANCE SIGN Indicator Lamp (red) (Fig.2
4) light is illuminated, it will go out at this point.
G Press down on the MAINTENANCE / MANUAL AUTO
button, and release the button when you hear a "beep."
If the MAINTENANCE / MANUAL AUTO button is held
down for more than 3 seconds, MANUAL AUTO Opera-
tion will begin (page 21).
G Please be sure to press the MAINTENANCE / MANUAL
AUTO button. Auto Filter Maintenance is unable to be
performed when the MAINTENANCE SIGN Indicator
Lamp (red) (Fig.2 4) is illuminated.
3. Insert the air filters into the unit (one on
both the left and right side).
Insert the air filter net into the dust box slot.
Dust Box
Insert the air filter until it reaches the upper limits of
the air filter frame (on both sides). (After about 2 sec-
onds, the air filter will automatically lock into its place).
Air filter
"Beep"
Air filter
Dust box
Mark
Air filter
frame
En-18