Rear Panel - ESI NeON Manual

ESI

2) Rear Panel

10. Power Switch :
Press the ʺ|ʺ to turn on NeON or the ʺOʺ to turn it off.
11. DC Power In :
Connect your power adapter here.
12. USB connector :
Use a USB cable to connect the NeON to your computer.
13. MIDI In/Out port :
The MIDI In/Out ports function as a 1x1 MIDI interface.
The MIDI Out port can be used in standalone mode if no USB cable is attached, or as a USB MIDI output
if a USB cable is connected. The MIDI In port will not function unless a USB cable is connected.
14. Sus.Pedal : By default, this jack is for a sustain pedal, but you can assign any switch type MIDI
controller number.
15. Mic In : This jack is the microphone input.
16. Hi‐Z In : This input allows you to directly connect an electric guiar or other high‐impedance signal.
17. Line In : You can connect unbalanced connectors (TS 1/4ʺ) to these inputs
18. Line Out : You can use unbalanced connectors (TS 1/4ʺ) to these inputs,
These jacks are connected to external audio devices (Speaker, Mixer, and so on.)
19. H.P Out : Plug your headphones in here. This jack is used for connecting headphone.
20. H.P Level : Adjusts the volume level of the headphone output.
WARNING: Please be careful when adjusting the headphone volume so it does not damage your ears!!!
6