ESI
3. Numeric Buttons ‐ This button can be used when you enter numerical value directly. And each button
has another function when you hold the SHIFT button:
No
1
2
3
4
5
6
7
8
9
0
4. Display LCD : This shows you the value of what you operate (parameter, MIDI channel etc.)
5. Oct+/‐ : This buttons can transpose up/down by octaves
6. Ctrl Wheel : You can assign parameter to this wheel for any use, by default
7. Dec/‐ and Inc/+ : You can increase or decrease a value by 1 when editing a parameter.
8. Function Buttons
SHIFT : To use another function, hold down this key and press button labeled what you want
Ctrl Assign : This button is used for assigning controller to MIDI controller or MIDI channel.
1~8/9~16 : NeON supports 16 knobs and encoders. It swaps all knobs and encoders between 1~8
mode and 9~16 mode.
Enter/Esc : Press this key to define the value or to exit from value setting mode.
Prg.Change : This button is used for Program change.
Panic : This button can send all notes off message to all channel, simultaneously.
9. Assignable Knobs, Encoders : You can assign a different MIDI Controller to each knob and encoder.
They can also be assigned independent MIDI channels.
Label
Vel, Curve
Vel, Offset
None
Sus, Pedal
MIDI CH
Data Entry Assign
PAD Assign
PAD MIDI CH
SAVE
RECALL
Please refer to chapter 10 for detailed descriptions
Function Descriptions
You can select the Velocity Curve
You can select the Velocity Offset
You can select MIDI Out port (See page 26)
You can select sustain pedal type
Select MIDI Channel
You can assign Data Wheel to MIDI Controller
Assign button to voice
Set the PAD MIDI Channel for PAD Assign
Save what you set
Recall setting you saved
5