Baby Lock ellegante 2 BLG2 Instruction And Reference Manual page 39

b
Slide the bobbin cover latch to the right.
a
a Bobbin cover
b Latch
→ The bobbin cover opens.
c
Remove the bobbin cover.
d
Hold the bobbin with your right hand and
hold the end of the thread with your left
hand.
e
Set the bobbin in the bobbin case so that
the thread unwinds to the left.
f
Hold the bobbin lightly with your right
hand, and then guide the thread with your
left hand.
g
b
h
Pass the thread through the guide, and then
pull the thread out towards the front.
a
a Cutter
→ The cutter cuts the thread.
Note
Make sure that the thread is correctly inserted
through the tension-adjusting spring of the
bobbin case. If it is not inserted correctly,
reinsert the thread.
a Tension-adjusting spring
CAUTION
• Be sure to hold down the bobbin with your
finger and unwind the bobbin thread correctly.
Otherwise, the thread may break or the thread
tension will be incorrect.
Insert the tab in the lower-left corner of the
bobbin cover (1), and then lightly press
down on the right side to close the cover
(2).
LOWER THREADING
1
1
27