Ryobi TSS101L Operator's Manual page 20

SQUARING THE BLADE TO THE FENCE
See Figures 18 - 21.
 Unplug the saw.
 Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
 Loosen the miter lock handle approximately one-half
turn.
 Rotate the miter table until the pointer on the control arm
is positioned at 0°.
 Securely tighten the miter lock handle.
 Lay a framing square flat on the miter table. Place one
leg of the square against the fence. Slide the other leg
of the square against the flat part of saw blade.
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
 The edge of the square and the saw blade should be
parallel as shown in figure 19.
 If the front or back edge of the saw blade angles away
from the square as shown in figures 20 - 21, adjustments
are needed.
 Loosen the socket head screws that secure the miter
fence to the miter table.
 Rotate the miter fence left or right until the saw blade is
parallel with the square.
 Retighten the screws securely and recheck the blade-to-
fence alignment.
The saw has two scale indicators, one on the bevel scale
and one on the miter scale. After squaring adjustments have
been made, it may be necessary to loosen the indicators
screws and reset them to zero.
Socket head
Screw(S)
Fence
ASSEMBLy
Socket head
Screw(S)
Fig. 18
20
Miter
Fence
Miter
taBle
View oF Blade SQuare with Fence
Miter
Fence
Miter
taBle
View oF Blade not SQuare with
Fence, adJuStMentS are reQuired
Miter
Fence
Miter
taBle
View oF Blade not SQuare with
Fence, adJuStMentS are reQuired
Blade
FraMinG
Miter
SQuare
lock handle
Fig. 19
Blade
FraMinG
SQuare
Fig. 20
Blade
FraMinG
SQuare
Fig. 21