Connecting An Antenna Or Cable Tv (No Box); Connecting A Dvd Or Blu-Ray Player - Dynex DX-24L230A12 User Manual

12
DX-24L230A12/DX-32L220A12/DX-46L261A12
Connecting an antenna or cable TV (no
box)
To connect an antenna or cable TV (no box):
1
Turn off your TV and all connected equipment.
2
Connect a coaxial cable (not provided) to the
ANT/CABLE IN jack on the back of your TV and to
the antenna or cable TV wall jack.
3
Turn on your TV, then go through the setup wizard
on page 18.
• Use a coaxial cable to eliminate interference and
noise from radio waves.
• Do not bundle the coaxial cable with the power
cord or other cables.
• If the antenna is not installed correctly, contact
qualified service personnel to correct the
problem.
Back of TV
L AUDIO R
Y P P
B R
COMPONENT IN ANT/ CABLE IN
Coaxial cable

Connecting a DVD or Blu-ray player

To connect a DVD or Blu-ray player:
1
Make sure that your TV's power cord is unplugged
and the DVD or Blu-ray player is turned off.
2
Connect an HDMI cable (not provided) to the HDMI1
or HDMI2 jack on the back or side of your TV and to
the HDMI OUT jack on the DVD or Blu-ray player.
DIGITAL OUTPUT
To play from a DVD or Blu-ray player:
1
Turn on your TV, then press INPUT to open the
INPUT SOURCE list.
2
Press or to select HDMI 1 or HDMI 2, then press
ENTER.
You can also press HDMI repeatedly to select HDMI1
or HDMI2.
3
Turn on the DVD or Blu-ray player, then set it to the
output mode. See the documentation that came
with the device for more information.
Making connections
Back of TV
AUDIO VGA
HDMI 1 PC IN
DVD or Blu-ray player
HDMI cable